HOME >Product information>Cooling tower products>indystrial (cross flow)         Item CROSS FLOW TYPE Exchange Type   ←Water ↓Air, Cross flow type Efficiency   When the amount of water is equal to the heat exchange coefficient, its volume is greater than that of   the counter flow type and theoretical interpretation tends to be more difficult. Distribution of air stream   Since the louvers are located on both sides, as the tower height increases, the fan is further away from   the air inlet. Therefore, dead space is generated in the heat exchange areas. Water spray device   The hot water tank and the nozzle are exposed to the outside. So, it is easy to perform repairs and   maintenance. In case of poor water quality, the system is still operable. Power   The fan generates vertical air flows. So, less obstacles exist and the static pressure loss is low. You   can use a lower power motor and save power consumption. Water spray pressure   Gravity is used to spray water. So the water spray pressure is relatively low. Tower height   The LOUVER, the FILLER and the ELIMINATOR are located on the same horizontal line. Thus, the   tower height is low. The filler height is equivalent to the tower height and the driving power of the pump   tends to be small. Area size of the tower   The LOUVER, the FILLER and the ELIMINATOR are located on the same horizontal line, so the area   size tends to be large. If you add a ventilator, it tends to be even larger. Temperature of the cold water tank   The temperature is not constant through the entire areas of the tank. The temperature at the edge of   the tank is lower than the middle area. Recirculation of the discharged air   The fan’s outlet is closely located to the louver, it is highly likely to recirculate hot and humid air that   was already discharged. Noise   Since the tower is not too tall and there is almost no separation between the filler and the cold water   tank, it generates less noise. Repair and maintenance   You can enter the tower through the entrance located in the middle of the tower. You can inspect the   tower in operation and partial repair and maintenance is easy to achieve. Price   A mid- or small-size is same as a counter flow type. If a large size is used, it will cost more than a   counter flow type. Item Comparison of materials(STANDARD MATTERIALS USED) FILLER & ELIMINATOR   DOUGLAS, FIR, PP, PS, PVC FRA ME   DOUGLAS FIR, SS400+HDG, RF CON'C, FRP, SUS304 FAN STACK   DOUGLAS FIR, SS400+EPOXY, SS400+HDG, RF CON'C, FRP, SUS304 CASING & LOUVER   DOUGLAS FIR, CACB, RF CON'C, FRP FAN DECK   DOUGLAS FIR, FRP, RF CON'C, SS400+HDG, SUS304, SS400+EPOXY HOT WATER BASIN   DOUGLAS FIR, FRP, RF CON'C, SS400+HDG, SUS304, SS400+EPOXY COLD WATER BASIN   FRP, RF CON'C, SS400+HDG, SUS304, SS400+EPOXY